▪ The first line is selected. Use the Scroll keys to select the setting to be
changed.
▪ Push the Enter key. The screen that follows is shown:
▪ The setting is shown in black.
▪ The upper and lower limits are shown in grey.
▪ Use the ▲ or ▼ keys to change the settings.
▪ Push the Enter key to select the new setting.
▪ If necessary, change the other settings in the same way as given above.
Indirect stop: occurs when the pressure decreases to the pre‑set Indirect stop
setpoint (= setpoint minus Indirect stop level). The motor will decelerate to
minimum speed and the inlet valve will close.
The settings (indirect stop level and direct stop level) are programmable, refer to
Programmable settings on page
75.
4.12. Event history menu
Menu icon, Event History
Function
To view the last shutdown and last emergency stop data.
Procedure
Start from the Main screen (Refer to
Main screen on page 33):
▪ Use the Scroll keys to move the cursor to the Menu action button.
▪ Push the Enter key. The screen that follows is shown:
Elektronikon® graphic controller
07/2021 - ©Atlas CopcoPage 521950840208_A
To Next Page
Loading...
Need help?
General
