FlexiROC T35 R/T40 R 5 Controls
55 No: 3171473547.1 en
f Activation of laser receiver (optional equipment).
At activation the laser symbol with grey back-
ground is shown in the status field and after a hit
the background changes to green.
Hole Depth
a The symbol indicates that vertical hole depth is
being displayed
b Drilling rate (m/min)
c Shows drill bit position
d Shows total drilled length (m)
e Current hole depth (m)
f Desired hole depth (m)
g Number of drill rods
h Reset of counter for desired hole depth
f Activation of laser receiver (optional equipment).
At activation the laser symbol with grey back-
ground is shown in the status field and after a hit
the background changes to green.
For further instructions, see the chapter "handling drilled length measurement".
To Next Page
Loading...
