FlexiROC T35 R/T40 R 5 Controls
54 No: 3171473547.1 en
Directional instrument - digital display mode.
a Shows required inclination angle of the feeder in
relation to the blast direction
b Shows desired lateral angle of the feeder
c Counter showing actual angle of inclination in rela-
tion to required blast direction
d Counter showing actual lateral angle of the feeder
in relation to required blast direction.
4 Drilled length
The window has two display modes, one which shows the actual hole length and one
which shows the vertical hole depth. Select display mode in menu 7, Settings.
Hole length.
a The symbol indicates that actual hole length is be-
ing displayed
b Drilling rate (m/min)
c Shows drill bit position
d Shows total drilled length (m)
e Current hole length (m)
f Desired hole length (m)
g Number of drill rods
h Reset of counter for desired hole length
To Next Page
Loading...
