WARNING
If one brake disc is damaged or worn, the other discs must also
be checked for damage and wear.
Removing
– Raise vehicle.
– Remove wheels.
Caution
On vehicles with ceramic brakes the wheel must not be allowed
to drop onto the brake disc. This would cause irreparable dam‐
age to the disc. Screw two assembly pins (from vehicle tool kit)
into the wheel bolt holes when removing and fitting a wheel.
Insert the long assembly pin into the top hole.
– Remove brake pads ⇒ page 95 .
– Detach brake caliper ⇒ page 90 .
Do not leave brake caliper hanging from brake hose but secure it
to bodywork using a suitable cable tie or wire. Take care that
brake hose is not damaged by weight of brake components.
– Remove locating bolt -8- from brake disc, holding brake disc
in position.
– Take brake disc off wheel hub.
Note
Take care to keep the brake disc straight when taking it off the
wheel hub.
Installing
– Clean contact surfaces of wheel hub and remove corrosion.
– Fit brake disc onto wheel hub.
Note
Take care to keep the brake disc straight when fitting it onto the
wheel hub.
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
102 Rep. gr.46 - Brakes - mechanism
To Next Page
Loading...
