8 - Wheel bolts
❑ Fitting wheels ⇒ Wheel/Tyre Guide
9 - Brake line connection to brake hose
❑ Tightening torque: 12 Nm
10 - Brake line
❑ Screw into brake caliper housing
❑ Screw into brake hose, counter hold on brake hose hexagon.
❑ Do not twist hose when fitting
❑ Ensure that lugs are properly seated in grooves in bracket.
11 - Brake line connection to brake caliper
❑ Tightening torque: 19 Nm
12 - Bracket
❑ Bolt to brake caliper housing
❑ Attach brake line
13 - Hexagon bolt M 8 x 16
❑ Tightening torque: 25 Nm
14 - Brake caliper housing
❑ If assembly work is required, do not leave caliper hanging from brake hose but secure it to body with
wire
❑ With the exception of “Renewing brake pads” ⇒ page 72 and “Servicing front brake caliper”, no repairs
may be performed on the brake caliper.
❑ Do not twist hose when installing
15 - Retaining spring
❑ Note correct installation position.
Note
The retaining spring must be push‐
ed under the brake carrier after en‐
gaging onto both studs. If incorrectly
installed, the wear of the outer pad
cannot be adjusted, and the pedal
travel will be increased as a result.
3.2 Removing and installing brake pads (PR
1LJ/1LL)
When renewing the brake pads, also check the brake disc for
wear. Refer to wear limit for brake disc
⇒ “1.2 Brakes, technical data”, page 1 .
Removing
Note
♦
♦
Mark brake pads when removing them if they are to be rein‐
stalled. Reinstall in their original position to prevent uneven
braking.
♦
When installing brake discs, note direction of travel -indicated
by arrow on brake disc- and fitting location -left or right-.
– Raise vehicle.
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
72 Rep. gr.46 - Brakes - mechanism
To Next Page
Loading...
