– Pull out pin -3-.
– Take out brake pedal.
Installing
Install in reverse sequence, paying attention to the following:
Attaching brake pedal to brake servo
– Hold ball head of push rod in front of mounting and push brake
pedal towards brake servo so that ball head audibly locks into
place.
– Install brake light switch ⇒ page 50 .
– Install brake light sensor ⇒ page 51 .
Caution
Make sure that the brakes work properly before the vehicle is
driven on the road.
9.2 Separating brake pedal from brake ser‐
vo
Special tools and workshop equipment required
♦ Release tool - T10159-
– Remove driver's storage compartment. ⇒ Rep. gr. 68
– Remove brake light switch ⇒ page 50 .
– Remove brake light sensor ⇒ page 51 .
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
118 Rep. gr.46 - Brakes - mechanism
To Next Page
Loading...
