Audi A6 2005 - Brake Caliper FNR G60; Servicing Brake Calipers

3 Brake caliper FNR G60
3.1 Servicing brake calipers
Note
♦ Install complete repair kit when servicing.
♦ Apply a thin coat of assembly paste - G 052 150 A2- to brake
cylinder, piston and seal.
♦ After servicing and installing brake caliper, bleed brake system
⇒ page 154 .
1 - Brake carrier
❑ Bolt to brake caliper
housing
2 - Guide pins, 30 Nm
3 - Caps
❑ Insert into bearing bush
4 - Protective cap
❑ Push onto bleeder valve
5 - Bleeder valve, 15 Nm
❑ Before screwing in,
grease thread with thin
coat of assembly paste -
G 052 150 A2- .
6 - Bearing bush
❑ Insert into brake caliper
housing
7 - Brake caliper housing
8 - Retaining spring
❑ Note correct installation
position.
❑ Engage onto both brake
caliper housing studs
and onto outer pad re‐
taining spring.
9 - Protective cap
❑ Do not damage when in‐
serting piston
❑ Grease with assembly
paste - G 052 150 A2- .
10 - Piston
❑ Apply a thin coat of as‐
sembly paste - G 052 150 A2- to piston before inserting
11 - Seal
❑ Grease with assembly paste - G 052 150 A2- .
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
134 Rep. gr.47 - Brakes - hydraulics