2 - Brake carrier
❑ Bolt to wheel bearing housing
3 - Ribbed bolt
❑ Tightening torque: 190 Nm
❑ Clean ribs if using again
❑ M14 × 1.5 x 38
4 - Bearing bush
❑ Insert into brake caliper housing
5 - Guide pin
❑
Tightening torque: 30 Nm
6 - Trim cap
❑ Take off
❑ Insert wear indicator wire in protective cap
7 - Brake disc
❑ Wear limit ⇒ page 1
❑ Detach brake caliper prior to removing
❑ Lightly lubricate contact surfaces between brake disc and wheel hub with polycarbamide grease.
WARNING
If one brake disc is dam‐
aged or worn, the other
discs must also be
checked for damage and
wear.
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
3. Front brakes (PR 1LJ/1LL) 71
To Next Page
Loading...
