Audi A6 2005 - Page 129

– Unscrew hexagon socket head bolt -1-, tightening torque
25 Nm.
– Remove mounting bracket.
Remove accelerator pedal.
Installing
Install in reverse sequence, paying attention to the following:
– First insert mounting pins in mounting bracket and bolt on
brake servo...
– ... then screw on multi-point socket head bolts -1-
Attaching brake pedal to brake servo ⇒ page 118
– Hold ball head of push rod in front of mounting and push brake
pedal towards brake servo so that ball head audibly locks into
place.
– Install brake light switch ⇒ page 50 .
– Install brake light sensor ⇒ page 51 .
Caution
Make sure that the brakes work properly before the vehicle is
driven on the road.
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
10. Removing and installing mounting bracket 123