– Remove wheels.
Note
♦
Ignition must be switched off at least 30 sec. before unplugging
connector.
♦
Clean whole area around connector and actuator motor/brake
caliper.
♦
Unplug connector -1- of actuator motor.
– Unscrew both securing bolts -1- on actuator motor.
– Detach actuator motor in direction of arrow
– Remove seal with suitable tool.
Make sure you do not damage annular groove for seal and con‐
tact surface on actuator motor.
Note
Do not use tools with sharp edges.
– If necessary clean annular groove and contact surfaces. Only
use brake cleaner.
Installing
– Fit new seal.
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
11. Overview of components - electronic parking brake and handbrake (EPB) 127
To Next Page
Loading...
