Audi A6 2005 User Manual

– Press in protective cap with special tool -1- and -2-.
– -Item 1-: Assembly tool for protective caps - T10146/1-
– -Item 2-: Piston resetting appliance - T10145-
Use jaw protectors
– Push protective cap onto brake caliper housing and press it in
so that it is seated flush -arrow-.
– At this stage it should not be possible to remove the protective
cap from the brake caliper housing by hand.
– Apply a thin coat of assembly paste - G 052 150 A2- to piston
and seal before inserting.
– Hold piston with standard extension and ratchet attachment
as shown in illustration and press lightly onto protective cap.
Keep the piston straight to avoid damaging the seal.
– Inflate protective cap with compressed air (maximum 3 bar).
The protective cap will then locate around the brake piston.
Use jaw protectors
– Press piston into brake caliper housing by hand.
Note
The inner sealing lip on the protective cap will then locate in the
piston groove.
Note
After servicing and installing brake caliper, bleed brake system
⇒ page 154 .
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
3. Brake caliper FNR G60 137

Audi A6 2005 Specifications

General

Brand	Audi
Model	A6 2005
Category	Automobile
Language	English