Audi A6 2005 - Page 39

14 - Brake light switch -F- and cruise control system brake pedal switch - F47-
❑ Removing and installing ⇒ page 50
❑ Removing and installing brake light sensor (new version) ⇒ page 51
❑ Can be checked in “Guided Fault Finding” using vehicle diagnostic, testing and information system - VAS
5051B- or -VAS 5052-
15 - Tandem brake servo
❑ Removing and installing ⇒ page 165
16 - Brake fluid level warning contact - F34-
17 - TCS and ESP button - E256-
❑ Fitting location: in centre console
18 - Brake pressure sender for ACC - G519-
❑ Fitting location: on brake pipe connector in engine compartment
❑ Replace old version with new version if necessary
Note
The brake system cannot be com‐
pletely bled if the older type of pres‐
sure sensor (1J0) is installed. Re‐
place the pressure sensor with the
new version (4F0) ⇒ ETKA .
❑ Removing and installing ⇒ page 54
❑ Tightening torque: 28 Nm
19 - Brake pressure sender for ACC - G518-
❑ Fitting location: on brake pipe connector in engine compartment
❑ Replace old version with new version if necessary
Note
The brake system cannot be com‐
pletely bled if the older type of pres‐
sure sensor (1J0...) is installed.
Replace the pressure sensor with
the new version (4F0...) ⇒ ETKA .⇒
❑ Removing and installing ⇒ page 54
❑ Tightening torque: 28 Nm
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
3. Exploded view - ABS/ESP components 33