– Secure brake caliper housing to brake carrier with both guide
pins (tighten to 30 Nm).
– Fit both caps.
– Make sure not to twist the brake hose when installing.
– Insert retaining spring into brake caliper housing.
– Attach brake line
– Connect wear indicator connector and insert wire in dust cap
and protective cap.
– Fit wheels ⇒ ELSA/ Wheel/Tyre Guide ⇒ Rep. gr. 44 .
Note
♦
The retaining spring must be pushed under the brake carrier
after engaging onto both studs. If incorrectly installed, the wear
of the outer pad cannot be adjusted, and the pedal travel will
be increased as a result.
♦
After installing the brake pads, depress the pedal firmly sev‐
eral times with the vehicle stationary, so that the pads are
properly seated in their normal operating position.
– Check brake fluid level and top up if necessary.
Caution
Make sure that the brakes work properly before the vehicle is
driven on the road.
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
76 Rep. gr.46 - Brakes - mechanism
To Next Page
Loading...
