Identification of Features and Options
IMD Option
The IMD (Intermodulation Distortion) measurement function is
available only if the IMD option has been installed. If present, this
option will be marked on the Options label on the rear panel (see
page 1-9). If not present, the front-panel IMD button will have no
effect.
The IMD measurement function conforms to the SMPTE and DIN
testing standards, and is described on page 4-26.
Connector Panel Options
The connector panel normally shipped with the ATS-1 Dual Domain
has 3-pin XLR connectors and banana jacks for the generator outputs
and analyzer inputs and is mounted on the front. This is the
configuration shown in the figures in this manual. Alternatively, the
connector panel may be mounted on the rear, and the speaker panel
mounted on the front.
Other connector panel options are available, and may be ordered with
the instrument or installed later by the user. Connector panel options
are:
.
BNC and banana jack connectors
.
WE-310 tip-ring-sleeve and banana jack connectors
.
1/4-inch phone and banana jack connectors
To install connector panel options or to swap the connector and
speaker panels, refer to Appendix C.
Optional Filters
In addition to the built-in filters, the ATS-1 provides two positions for
optional filters that can be installed in the field. Refer to Appendix C
for cautions and installation procedure.
1 Description
Identification of Features and Options Description
1-8 ATS-1 Dual Domain User's Manual
To Next Page
Loading...
Need help?
General
