AudioCodes Mediant 800 MSBG - Table 2-2: Front-Panel Description

Installation Manual 12 Document #: LTRT-10205
Mediant 800 MSBG
Table 2-2: Front-Panel Description
Item
#
Label
Description
1
POWER /
STATUS /
WAN
LEDs indicating the status of the power, reboot/initialization, and WAN
interface.
2
FXS / FXO /
BRI / Digital
These I/O interfaces can include the following interface groups, depending
on the ordered model:
• FXS interfaces, providing four RJ-11 ports per group.
• FXO interfaces, providing four RJ-11 ports per group.
• BRI interfaces, providing up to four BRI S/T interface RJ-45 ports
(thereby supporting up to eight voice channels) for connecting ISDN
terminal equipment such as ISDN telephones.
• E1/T1 interface, providing an RJ-48 port.
Notes:
• The FXS/FXO interfaces support loop-start signalling (indoor only).
• The device can be ordered with one type of telephony interface or a
combination thereof. For supported hardware configuration options, refer
to the Release Notes.
3
-
Reset button for resetting the device and optionally, for restoring the device's
parameters to their factory defaults (refer to 'Restoring Factory Default
Settings' on page 56).
4
GE/T1/SHDSL
WAN interface – can be one of the following:
 RJ-45 port (10/100/1000Base-T)
 RJ-48c Data Service Unit/Channel Service Unit (DSU/CSU) dual T1 WAN
port, for connecting up to two T1 lines
 Symmetric High-Speed Digital Subscriber Line (SHDSL) RJ-45 port (4
wire pairs)
5
GE
Up to four RJ-45 10/100/1000Base-T (Gigabit Ethernet) LAN ports for
connecting to IP phones, computers, or switches. These ports support half-
and full-duplex modes, auto-negotiation, and straight or crossover cable
detection.
These ports support Power over Ethernet (PoE), complying with the IEEE
802.3af-2003 standard. The ports automatically detect the presence of IEEE
802.3af-compliant devices. The maximum wattage available per port is
15.4W. The maximum wattage available for all ports (GE and FE) combined
is 120W.
Note: PoE support is a customer ordered feature.
6
FE
Eight RJ-45 10/100Base-TX (Fast Ethernet) LAN ports for connecting to IP
phones, computers, or switches. These ports support half- and full-duplex
modes, auto-negotiation, and straight or crossover cable detection.
These ports support PoE, complying with the IEEE 802.3af-2003 standard.
The ports automatically detect the presence of IEEE 802.3af-compliant
devices. The maximum wattage available per port is 15.4W. The maximum
wattage available for all ports (GE and FE) combined is 120W.