Version 6.2 15 February 2011
Installation Manual 2. Installing the Device
2.3 Mounting the Device
The device can be mounted in one of the following ways:
Placed on a desktop (refer to 'Desktop Mounting' on page 15)
Installed in a
standard 19-inch rack (refer to '19-Inch Rack Mounting' on page 16)
Warning: Do not place any equipment directly on top of the device or adjacent to its
sides (at least 13-cm separation). In addition, if you are mounting the
device in a 19-inch rack, ensure that at least a 3U separation is maintained
between the device and other mounted devices or equipment.
2.3.1 Desktop Mounting
The device can be placed on a desktop when its four anti-slide bumpers (supplied) are
attached to the underside of the device.
Figure 2-3: Rubber Foot Attached to Underside of Device
¾ To attach the anti-slide rubber bumpers to the device:
1. Flip the device over so that its underside faces up.
2. Locate the four anti-slide grooves on the underside - one in each corner.
3. Peel off the adhesive, anti-slide rubber feet and stick one in each anti-slide groove.
Figure 2-4: Peeled-off Rubber Foot
4. Flip the device over again so that it rests on the rubber feet and place it in the required
position on a desktop.
To Next Page
Loading...
