Version 6.2 57 February 2011
Installation Manual 3. Configuring the Device
3.8 Upgrading the Device
You can upgrade the device with the following files, using the device's Web interface:
Firmware (cmp) file using the Web interface's Software Upgrade Wizard (refer to
‘Upgrading Firmware’ on page 57).
Auxiliary and ini files usi
ng the 'Load Auxiliary Files' page (refer to 'Loading ini and
Auxiliary Files' on page 60).
Note: When upgrading the firmware (cmp), you can also use the Software Upgrade
Wizard to load the ini and auxiliary files.
3.8.1 Upgrading Firmware
The Software Upgrade Wizard allows you to easily upgrade the device's firmware (cmp file)
as well as load an ini file and/or auxiliary files (e.g., Call Progress Tones). However, it is
mandatory, when using the wizard to first load a cmp file to the device. You can then
choose to also load an ini file and/or auxiliary files, but this cannot be pursued without first
loading a cmp file. For the ini and each auxiliary file type, you can choose to load a new file,
or not load a file but use the existing file (i.e., maintain existing configuration) running on the
device.
Warnings:
• Before upgrading the device, it is recommended that you save a copy of
the device's configuration settings (i.e., ini file and data file) to your PC. If
an upgrade failure occurs, you can then restore your configuration
settings by uploading the backup files to the device. For saving and
restoring configuration, refer to 'Backing Up and Restoring Configuration'
on page 55.
• The Software Upgrade Wizard requires the device to be reset at the end
of the process, which may disrupt traffic. To avoid this, disable all traffic
on the device before initiating the wizard by performing a graceful lock
(refer to 'Saving Configuration and Resetting the Device' on page 53).
Notes:
• Before you can load an ini or any auxiliary file, you must first load a cmp
file.
• When you activate the wizard, the rest of the Web interface is
unavailable. After the files are successfully loaded, access to the full Web
interface is restored.
To Next Page
Loading...
