AudioCodes Mediant 800 MSBG - Restoring Factory Default Settings

Installation Manual 56 Document #: LTRT-10205
Mediant 800 MSBG
¾ To load (or restore) the ini file:
1. To load the Voice ini file to the device, perform the following:
a. Click the Browse button, navigate to the folder in which the ini file is located,
select the file, and then click Open; the name and path of the file appear in the
field beside the Browse button.
b. Click the Load INI File button, and then at the prompt, click OK; the device
uploads the ini file and then resets (from the cmp version stored on the flash
memory). Once complete, the Login screen appears, requesting you to enter your
user name and password.
2. To load the Data configuration ini file to the device, perform the following:
a. Under the 'Send the Data Configuration file to the device' group, click the Browse
button, navigate to the folder in which the file is located, select the file, and then
click Open; the name and path of the file appear in the field beside the Browse
button.
b. Click the Send File button, and then at the prompt, click OK; the device uploads
the file and then resets (from the cmp version stored on the flash memory). Once
complete, the Login screen appears, requesting you to enter your user name and
password.
3.7 Restoring Factory Default Settings
You can use the device's hardware Reset button to restore all the device's configuration
settings to factory defaults, including the device's IP address and Web interface's login user
name and password.
Notes:
• The device resets to the software version (cmp file) saved on its flash
memory.
• For additional methods to restore default settings, refer to the User's
Manual.
¾ To restore the device to factory default settings:
 With a paper clip or any other similar pointed object, press and hold down the Reset
button (located on the front panel) for at least 12 seconds, but no more than 25
seconds; the device restores to factory default settings.