AudioCodes Mediant 800 MSBG - Figure 3-21: Defining SIP Ports (E.g. TCP); Figure 3-22: Traffic Matching Rule for Received SIP Signaling Traffic

Version 6.2 49 February 2011
Installation Manual 3. Configuring the Device
Figure 3-21: Defining SIP Ports (e.g. TCP)
d. Define the protocol (TCP and UDP) and their ports, and then click OK.
e. Click OK again.
f. Perform steps 2b through 2e to configure ports for outgoing SIP packets.
g. Under the 'Operation' group, select the 'Set Tx Class Name' check box, and then
from the corresponding drop-down list, select the traffic shaping class 'VOIP Tx',
which you defined in 'Defining VoIP Tx Shaping Class' on page 50.
The co
nfigured incoming and outgoing SIP ports are shown below:
Figure 3-22: Traffic Matching Rule for Received SIP Signaling Traffic
h. Click OK.