Version 6.2 35 February 2011
Installation Manual 3. Configuring the Device
3 Configuring the Device
This section describes initial, basic setup configuration for the device, using the device's
embedded Web server (Web interface).
Notes:
• The device is supplied with application software (cmp file) already
residing on its flash memory. This software is set to factory defaults.
• If necessary, after modifying configuration, you can restore the device to
factory defaults (refer to 'Restoring Factory Default Settings' on page 56).
• For a detailed description on how to fully configure the device, refer to the
User’s Manual.
3.1 Initial Web Interface Access
The device’s embedded Web server (Web interface) is initially accessed using the default
LAN VoIP and Management interface IP address. Once you have accessed the Web
interface, you can change the IP address to suite your networking scheme and configure
the device as discussed in later sections.
Note: Once you have accessed the device through the LAN interface, you can
configure the device for remote HTTP/S device access from your WAN port
interface. For defining the WAN interface and remote access, refer to
‘Enabling Remote HTTP/S Web Management’ on page 51.
The default LAN VoIP and Management interface IP address is listed in the table below:
Table 3-1: Default LAN VoIP and Management IP Address
Parameter Default Value
IP Address
192.168.0.2
Subnet Mask
255.255.255.0
Default Gateway
192.168.0.1
To Next Page
Loading...
