Version 6.2 29 February 2011
Installation Manual 2. Installing the Device
¾ To connect the OSN server's port interfaces:
1. Connecting computer peripherals: on the rear panel, connect a USB plug to one of
the USB (Standard-A type) ports (labeled USB), and then connect the other end of the
USB cable to the peripheral device.
2. Connecting to a monitor: on the rear panel, connect a 15-Pin D-type male connector
to the VGA female port (labeled VGA), and then connect the other end of the cable to
a monitor.
3. Connecting the Ethernet ports: on the rear panel, connect an RJ-45 Ethernet cable
to the Gigabit Ethernet port/s (labeled GE 1 and GE 2), and then connect the end to
the desired network.
Figure 2-20: Cabling OSN Server Ports
4. Connect the device to power.
5. Insert the operating system CD media (Linux or Microsoft Windows) into the CD-ROM
drive.
6. Continue according to the CD's installation instructions.
¾ To reset the OSN server:
Insert a sharp-pointed object (such as a drawing pin) into the Reset pinhole and then
extract it after a second; the OSN server performs a reset.
To Next Page
Loading...
