Installation Manual 32 Document #: LTRT-10205
Mediant 800 MSBG
2.4.10 Powering up the Device
The device receives power from a standard alternating current (AC) electrical outlet. The
connection is made using the supplied AC power cord.
Warnings:
• The device must be connected to a socket-outlet providing a protective
earthing connection.
• Use only the AC power cord that is supplied with the device.
• For replacing the power fuse, refer to Section 2.5.1 on page 33.
¾ To connect the device to the power supply:
1. Connect the line socket of the AC power cord (supplied) to the device's AC power
socket (labeled 100-240V 1.5A ~50-60 Hz), located on the rear panel.
Figure 2-22: Cabling the Power
2. Connect the plug at the other end of the AC power cord to a standard electrical outlet.
To Next Page
Loading...
