Version 6.2 37 February 2011
Installation Manual 3. Configuring the Device
3.2 Basic Setup Configuration
Basic setup depends on whether you want to implement both the VoIP and data-routing
functionalities, or only the VoIP functionality.
3.2.1 VoIP and Data-Routing Functionalities
For implementing the both VoIP and data-routing functionalities, perform the following basic
procedures:
Configure the VoIP and management LAN IP address and the data-routing LAN IP
address (refer to 'Assigning LAN IP Addresses' on page 37)
Config
ure the data-routing DHCP server (refer to ‘Configuring the Data-Routing DHCP
Server’ on page 39)
Config
ure the data-routing WAN IP address (refer to ‘Assigning Data-Routing WAN IP
Address’ on page 40)
As
signing the WAN interface to the VoIP traffic (refer to 'Assigning WAN Interface to
VoIP Network' on page 42).
Configure data-routing QoS (refer to ‘Configuring Data-Routing Quality of Service’ on
page 44)
Enable remot
e Web management (refer to Defining ‘Enabling Remote HTTP/S Web
Management’ on page 51)
Figure 3-2: S
teps for Configuring VoIP and Data-Routing Functionalities
3.2.1.1 Assigning LAN IP Addresses
You need to define LAN IP addresses for the following interface services:
VoIP and management (OAMP, Media, and Control) - refer to “VoIP and Management
LAN Interface” on page 38
Data-ro
uting (with security) - refer to “Data-Routing LAN Interface” on page 38
To Next Page
Loading...
