Installation Manual 40 Document #: LTRT-10205
Mediant 800 MSBG
4. Define the IP address pool.
Figure 3-6: Configuring the DHCP Server
5. Click OK.
6. If required, refresh the address by disconnecting the cable and then reconnecting it
again, or by performing the following in the Windows’ command line interface:
ipconfig /release
ipconfig /renew
3.2.1.3 Assigning Data-Routing WAN IP Address
Once you have configured the device's LAN interfaces, you can then define the device's
WAN interface (for connecting to the Internet). The WAN interface connection can be
Ethernet, T1 WAN, or SHDSL. This section only describes how to manually configure the
Ethernet WAN interface; for detailed information regarding the other WAN connections,
refer to the User’s Manual.
Note: Before you configure the WAN interface connection, ensure that you have all
the required information from your ISP.
¾ To assign a WAN IP address:
1. Cable the device to the WAN network (i.e., ADSL or Cable modem), using the WAN
port (refer to ‘Connecting to WAN’ on page 20).
2. Acce
ss the device's Web interface with the Voice and Management IP address.
3. Access the 'Settings' page (Configuration tab > Data menu > WAN Access >
Settings).
To Next Page
Loading...
