Installation Manual 38 Document #: LTRT-10205
Mediant 800 MSBG
3.2.1.1.1 VoIP and Management LAN Interface
The procedure below describes how to assign an IP address to the LAN VoIP and
Management interface.
Notes:
• The VoIP and Management interface must be in the same subnet as the
data-routing interface.
• When operating with VoIP and data-routing functionalities, it is
recommended to define the Default Gateway IP address for the VoIP
network interfaces in the same subnet and with the same VLAN ID as the
IP address defined later for the data-routing LAN interface.
¾ To assign a LAN VoIP and Management IP address:
1. Open the ‘IP Settings’ page (Configuration tab > VoIP menu > Network submenu >
IP Settings).
2. Select the 'Index' radio button corresponding to the Application Type "OAMP + Media
+ Control” (i.e., VoIP and management interface), and then click Edit.
3. Configure the new IP address and prefix length so that it corresponds to your network
IP addressing scheme (e.g., 10.8.6.86).
4. Configure additional IP interfaces, if required.
Figure 3-3: Multiple Interface Table Page
5. Click Apply and then Done to apply and validate settings. If validation fails, the device
does not reboot.
6. Save your settings to flash memory and reset the device (refer to 'Saving Configuration
and Resetting the Device' on page 53).
3.2.1.1.2 Data-Routing LAN Interface
The default IP address of the LAN data-routing interface is listed in the table below:
Table 3-2: Default LAN Data-Routing IP Address
Parameter Default Value
IP Address
192.168.0.1
Subnet Mask
255.255.255.0
Default Gateway
0.0.0.0
Note: The LAN data-routing interface must be in the same subnet as the VoIP and
Management interface.
To Next Page
Loading...
