Installation Manual 18 Document #: LTRT-10205
Mediant 800 MSBG
2.4 Cabling the Device
This section describes the cabling of the device, which includes the following:
Connecting to earth/ground (refer to ‘Grounding the Device’ on page 19)
Protective Earthing
The equipment is classified as Class I EN60950 and UL60950 and must be
earthed at all times. Therefore, before connecting the device to power and
communication interfaces (listed below), you must earth the device.
Connecting to the IP (WAN) Ethernet network (refer to 'Connecting to WAN' on page
19)
Con
necting to the LAN (refer to 'Connecting to LAN' on page 21)
Con
necting the FXS/FXO interfaces (refer to 'Connecting to FXS/FXO Interfaces' on
page 24)
Con
necting the analog Lifeline telephone (refer to ‘Connecting to Analog Lifeline
Phone' on page 25)
Con
necting to ISDN BRI equipment (refer to ‘Connecting to ISDN BRI Lines’ on page
27)
Con
necting to E1/T1 trunks (refer to ‘Connecting to E1/T1 Trunks’ on page 28)
Con
necting the OSN server (refer to 'Connecting the OSN Server' on page 27)
Con
necting to a PC for serial communication (refer to ‘Connecting the Serial Interface
to a PC’ on page 29)
Con
necting the device to the power supply (refer to ‘Connecting to the Power Supply’
on page 32)
Once you ha
ve cabled and powered-up the device, the POWER LED on the front panel
lights up green. For a description of the LEDs, refer to 'Monitoring Front-Panel LEDs' on
page 61. On
ce you have cabled the device, you can begin configuring the device (refer to
'Configuring the Device' on page 35).
To Next Page
Loading...
