AudioCodes Mediant 800 MSBG - SHDSL WAN Cabling; Figure 2-11: Connecting the SHDSL WAN Port; Table 2-5: RJ-45 Connector Pinouts for SHDSL

Installation Manual 22 Document #: LTRT-10205
Mediant 800 MSBG
2.4.2.3 SHDSL WAN Cabling
The SHDSL port has four wire-pairs, supporting up to four SHDSL WAN ports on a single
physical connector (RJ-45). SHDSL port specifications:
 Conforms to ITU G.991.2 Annexes A, B, E, F and G SHDSL
 Up to 5,696 Kbps over a single wire pair
 Up to 22,784 Kbps over four wire pairs bonding, according to SHDSL.bis (ITU G.991.2
Annexes F, G)
 EFM and ATM support
 Wetting current support on the CPE side, according to G991.2
 Supports both Central Office (CO) and CPE (wetting current on CO - excluded)
 TC-PAM 16/32 line code
¾ To connect the device’s SHDSL WAN port to an SHDSL access point:
1. Connect an RJ-45 SHDSL cable to the device’s SHDSL WAN port (labeled SHDSL).
Figure 2-11: Connecting the SHDSL WAN Port
2. Connect the other end of the cable to the access point.
The RJ-45 connector pinouts are described in the table below:
Table 2-5: RJ-45 Connector Pinouts for SHDSL
Pin Function
4
CH0-TIP
5
CH0-RING
1
CH1-TIP
2
CH1-RING
3
CH2-TIP
6
CH2-RING
7
CH3-TIP
8
CH3-RING