Version 6.2 59 February 2011
Installation Manual 3. Configuring the Device
7. You can now choose to either:
• Click Reset; the device resets, utilizing the new cmp and ini file you loaded up to
now as well as utilizing the other auxiliary files.
• Click Back; the 'Load a cmp file' page is opened again.
• Click Next; the next page opens for loading the data routing configuration and
next consecutive auxiliary file listed in the Wizard.
8. For loading the auxiliary files, follow the same procedure as for loading the ini file
(Step 6).
9. In the 'FINISH' page, complete the upgrade process by clicking Reset; the device
'burns' the newly loaded files to flash memory and then resets the device.
Note: Device reset may take a few minutes (depending on cmp file version, this may
take up to 30 minutes).
After the device resets, the 'End Process' screen appears, displaying the burned
configuration files (refer to the figure below).
Figure 3-34: End Process Wizard Page
10. Click End Process to close the wizard; the 'Enter Network Password' dialog box
appears.
11. Enter your login user name and password, and then click OK; a message box appears
informing you of the new cmp file.
12. Click OK; the Web interface becomes active, reflecting the upgraded device.
To Next Page
Loading...
