USER’S MANUAL / bit Tune /
92
5. Select “Update Firmware” from the “SETTINGS” menu. The program will ask you to select the file you
just saved from the Download area or previously saved to your PC.
6. Before starting the update of the bit Tune, the program provides the
following warnings:
- Do not disconnect the bit Tune from the PC.
- Do not disconnect the bit Tune from power supply.
- Temporarily disable the automatic suspension processes on your PC.
- Temporarily disable the Screen Saver processes on your PC.
- Close any other open application.
- Temporarily disable anti-virus and anti-spy ware software.
7. Once the OK is given, start the Firmware update of the bit Tune.
This process takes from 30 seconds to 1 minute and its correct
progress will be indicated by the time bar.
8. The successful update is indicated by the message window.
9. Turn the bit Tune off and on.
10. Repeat the HSM microphone calibration (see sect. 7.2)
WARNING: During the upgrade, the progress of the bar may stop for a few seconds.
Do not interrupt the process in any way.
9
To Next Page
Loading...