auer 6P10 PILOT - Table of Contents

- 6P10 PILOT MANUAL -
2
SOMMAIRE
1-SAFETY ............................................................. 4
2 -PLEASE READ IMMEDIATELY ......................... 6
2.1 - Conservation of documents ............................................................6
2.2 - Symbols used ........................................................................................6
2.3 - Abbreviations and acronyms ...........................................................6
2.4 - Delivery terms and conditions ........................................................6
2.5 - Storage and transport ........................................................................6
2.6 - Unpacking ..............................................................................................6
2.7 - Rating plate ............................................................................................6
2.8 - End of life of the appliance ...............................................................6
3 - INTRODUCTION ............................................. 7
3.1 - General information ...........................................................................7
3.2 - Packaging ...............................................................................................7
3.3 - Accessories (included) .......................................................................7
3.4 - Accessories available as optional extras ......................................7
3.5 - Operating principles ...........................................................................8
4 - INSTALLATION ................................................ 8
4.1 - Placement choice.................................................................................8
4.1.1 - Appropriate placement choice ............................................................................8
4.1.2 - Fixation ......................................................................................................................... 8
4.1.3 - Dimensions .................................................................................................................9
4.2 - Hydraulic installation ..........................................................................9
4.2.1 - Recommendations ...................................................................................................9
4.2.1.1 - Back ow prevention device .................................................................9
4.2.1.2 - Cross sections, purging of the heating circuits ............................. 9
4.2.1.3 - Desludging tank .......................................................................................9
4.2.1.4 - Preparing the hydraulic circuit (rinsing) ..........................................9
4.2.1.5 - Insulation of the pipes ...........................................................................9
4.2.1.6 - Expansion vessel ......................................................................................9
4.2.1.7 - Frost protection ......................................................................................10
4.2.1.8 - Thermostatic valves...............................................................................10
4.2.1.9 - Treatment of the water in the heating circuit ..............................10
4.2.1.9.1 - Filling water ..........................................................................10
4.2.1.9.2 - Treatment of the heating circuit ...................................10
4.2.1.10 - Installation of the DHW circuit ........................................................11
4.2.1.11 - Purging the installation .....................................................................11
4.2.1.12 - Connecting the pressure relief valve ............................................11
4.2.1.13 - Filter on the water inlet of each heat pump (supplied) .........12
4.2.2 - Hydraulic connections ..........................................................................................12
4.2.2.1 - Back-up boiler connection .................................................................12
4.2.2.2 - Distribution circuits connection (DHW/heating)........................13
4.2.2.2.1 - Hydraulic circuits sizing between HRC
70
pilot
and water tanks primary coils .......................................13
4.2.2.3 - UPMXL 25-125 circulator for heat pump circuits
and distribution (DHW/heating) ......................................................13
4.2.2.3.1 - Manometric height/Flow rate .......................................13
4.2.2.3.2 - Setting of the circulator pump
on the CP3 constant pressure mode...........................13
4.3 - Electrical connections ......................................................................14
4.3.1 - Power electrical connections .............................................................................14
4.3.2 - Prior recommandations before power electrical connections ..............14
4.3.3 - Power electrical connection of the pilot ..................................................................14
4.3.4 - Power connection of the HRC
70
heat pump ........................................................15
4.3.5 - Control connection of the heat pump ............................................................15
4.3.6 - Cascade of heat pumps ........................................................................................16
4.4 - Connection of circuits and accessories ......................................17
4.4.1 - Room thermostat ...................................................................................................17
4.4.2 - Exterior sensor .........................................................................................................17
4.4.3 - Domestic water aquastat .....................................................................................17
4.4.4 - Domestic water sensor .........................................................................................17
5 - SET-UP ...........................................................18
5.1 - Before set-up ............................................................................................................... 18
5.2 - Check watertightness.......................................................................18
5.3 - Starting set-up ....................................................................................18
5.3.1 - Step 1 : Number of heat pump ..........................................................................18
5.3.2 - Step 2 : Circuits choice ..........................................................................................18
5.3.3 - Step 3 : Filling ...........................................................................................................19
5.3.4 - Step 4 : Purging the installation ........................................................................19
5.3.6 - Step 6 : Finishing set-up .......................................................................................19
5.3.5 - Step 5 : Choosing the back-up ...........................................................................19
5.4 - First use..................................................................................................19
6 - SETTINGS AND FUNCTIONS .......................20
6.1 - Control panel .......................................................................................20
6.1.1 - Keypad ........................................................................................................................20
6.1.2 - Display ........................................................................................................................20
6.2 - Menus ....................................................................................................21
6.3 - Actions to be activated using a combination of buttons ....21
6.4 - List of parameters which can be set ..........................................22
6.5 - Description of functionalities ........................................................25
6.5.1 - Functions related to heating ..............................................................................25
6.5.1.1 - AUTO temperature (heat curve) .......................................................25
6.5.1.2 - Lowering of the temperature ............................................................25
6.5.1.3 - Auto-adaptability ...................................................................................25
6.5.1.4 - Ambient temperature reactivity .......................................................25
6.5.2 - Programming and timeout functions .............................................................25
6.5.2.1 - Anticipation of return from holiday ................................................25
6.5.2.2 - Automatic summer/winter changeover ................................................................26