- INSTALLER HIGHTEMPERATURE ENERGY EFFICIENT HEAT PUMP MANUAL -
4
1.1 - Important information
1 - PLEASE READ IMMEDIATELY
These installation and operating instructions form part of the appliances which they refer to. In order for the warranty to be valid,
they must be read before using the appliance.
This manual must be kept and passed on to successive users for future reference. It will be considered as
evidence in case of litigation.
The high temperature Heat Pump absorbs the calories contained in outdoor air, transforms them into useful energy and transfers them to
the heating water for your home. AUER cannot be held responsible for any other usage of the appliance.
The safety advice and instructions which are given here must be strictly respected.
Before making any connections, make sure that the appliances are compatible with the installation.
Before switching the system on, make sure that the network voltage to be applied to the appliances is the same as the voltage indicated on
their rating plates.
Before undertaking any maintenance or handling or in case of the appliances functioning incorrectly or not at all, always disconnect from
the mains power supply and seek advice from a specialist.
AUER declines any responsibility for damage caused by these instructions not being followed and any errors due to improper handling,
installation or usage.
These installation and operating instructions are subject to change without prior notice.
- It is the responsibility of the installer and
the client to contact the electricity provider and
ensure that the appliance is compatible with
the power grid before connecting the HRC
70
Heat Pump (see the information form which is
an appendix to this document).
- The power grid impedance value must be less
than the Hea
t Pump impedance Z
max
(see §
"Connecting the HRC
70
Heat Pump to the power
supply").
- If electrical installation standards are not
respected, irreversible damage could be
sustained to the HRC
70
Heat Pump, which will
not be covered by the manufacturer’s warranty.
ELECTRICAL INSTALLATION
RECOMMENDATIONS
- Rinse and clean the hydraulic heating
circuit before connecting the Heat Pump
and Pilot.
- The appliance only works when lled with
water. Never switch the appliance on if it has not
been properly purged and lled with water.
- The lter valve protects the Heat Pump; an
annual check on the condition of the lter must
be carried out.
- We recommend that you check for sludge
and limescale from time to time and clean if
necessary. The appliance must be switched o
before any cleaning is undertaken.
- Always switch the appliance o before working
on any electrical parts.
Caution: the fan may still continue to run
through inertia even when the appliance has
ben switched o .
- Never put water on the control components
or any electrical parts. Switch o the appliance
before cleaning.
HYDRAULIC INSTALLATION
RECOMMENDATIONS
To Next Page
Loading...
