auer HRC70 17 - A8 - Electricity Provider Information Form

- INSTALLER HIGHTEMPERATURE ENERGY EFFICIENT HEAT PUMP MANUAL -
82
This form is to give to your electricity provider for any preliminary study undertaken for installing a HRC Heat Pump, in case of insu cient
supply from the power grid.
This table recapitulates both information on electrical installation and HRC Heat Pump technical data.
You can  nd the technical data in the table in the § "Connecting the HRC Heat Pump to the power supply" section.
If necessary, your electricity provider can reinforce the power lines after the installation study.
A8 - Electricity provider information form
Name of client
Address
Client reference number on electricity bill
Name and address of installer
Connections
Single phase  Three phase  *
Circuit breaker Setting: ________A
Heat Pump (HP)
Type of pump
Single phase  Three phase  *
Model, make and reference number ______________________________________________________________
Type of compressor (without back-up heating)
Single phase  Three phase  *
Nominal heating capacity of Heat Pump without
elements for heating back-up (kVA)
________(kVA) *
Or Or
HP nominal current without elements for heating
back-up (A)
________(A) *
HP start-up current (A) ________(A) *
HP impedance (Z
max
) declared by manufacturer
________(
HP power regulating mode
Fixed speed  Variable speed 
Is there a start-up support system in place for
 xed-speed systems?
Yes * No *
-
Elements for heating back-up
Single phase  Three phase  *
________(kVA)
* mandatory  elds