Autonics TK Series User Manual

6 Parameter Settings and Functions
106 © Copyright Reserved Autonics Co., Ltd.
6.7.9.1 Password entry [PASS]
If password protection is turned on, accessing SV parameters or groups when the unit is in RUN
mode will prompt a password confirmation parameter [PASS]. Then, the correct password has to
be entered to access the setting parameters.
 Settings
1st Access SV parameter or parameter group.
2nd When prompted with PASS, use the key to select the desired digit.
3rd Use the keys to enter the password (0001 through 9999) and then press the
key.
 If the correct password is entered, you can access setting parameters.
 If an incorrect password is entered, repeat steps 2 and 3 and enter the correct password.
Setting
group
Parameter Setting range
Factory
default
Unit
PAR5 PASS
0001 (read-only), 0002 to 9999
0001 -
If the password is unknown, enter 0001 to access the parameters in read-only mode.
This parameter only appears if the setting from 6.7.9
Password settings [PAR5 → PWD] is set to a
value other than 0000.
If an incorrect password has been entered, the SV display section displays a coded form of the
password stored by the user and an error message [ERR]. Then, the error message flashes in 1
sec. intervals.
6.7.9.2 Password recovery
Entering an incorrect password displays a coded form of the password on the SV display. Submit
this code to Autonics to recover your lost password.
Incorrect Password Entry (For example, the correct password being1234)
1st Access SV parameter or parameter group.
2nd When prompted with PASS, use the key to select the desired digit.
Use the keys to select 4321(incorrect password) and then press the key.
Entering an incorrect password displays a coded password on the SV display. An ERR
message will also appear, flashing at 1 sec. intervals.

Autonics TK Series Specifications

General

Brand	Autonics
Model	TK Series
Category	Temperature Controller
Language	English