Autonics TK Series User Manual

5 Preparation and Startup
© Copyright Reserved Autonics Co., Ltd. 43
※1.
PASS
parameter will be displayed only when password is set. It is not displayed when
purchasing the unit since default password is set to
0000
.
If password is not valid, the screen will be shifted to password code required window.
Press any key among to return to password entering window. Press
key to return to RUN mode.
In case you forget password, contact Autonics after checking password code.
※2. TK4N/4S/4SP do not have key. The key replaces key.
※3. It is displayed when setting user parameter group in the comprehensive device
management program (DAQMaster).
 Hold the key over 2 sec in RUN mode to enter into setting mode.
 Hold the key for 1.5 sec while in setting mode to move to other parameter group.
 Hold the key over 3 sec while in setting mode to return to RUN mode.
 Press the key at the last parameter of each parameter, it moves to that parameter
name. You can move to other groups.
 If there is no additional key operation within 30 sec after entering into setting mode, it will be
automatically returned to RUN mode and previous setting value will be remained
 The shaded parameters are displayed in common.
The others may not be displayed by the specifications of the product, other parameter’s
setting, or parameter mask setting.

Autonics TK Series Specifications

General

Brand	Autonics
Model	TK Series
Category	Temperature Controller
Language	English