System Units – Overview
asafeinstall_dgb, AutroSafe Interactive Fire Detection System, Release 4,
116-P-ASAFE-INSTALL/DGB, Doc-1004796-2, 2021-08-23, Autronica Fire and Security AS
Page 16
Controller BC-420
The Controller, BC-420, serves as a connection unit
for the detection loop, alarm sounders, controls and
inputs.
It can accommodate up to a maximum of 12 modules.
The panel provides connections for:
• 2 Ethernet ports and 2 USB host ports
• 1 RS-232, RS-422 or RS-485 serial port for
communication with third party equipment
• 1 AutroFieldBus (AFB) interface
• 1 AlCom+ interface
• Panel Operational State output
Dimensions:
HxWxD (mm): 350 x 350 x 161
Controller BC-440
The Controller Rack Unit BC-440 serves as a
connection unit for the detection loop, alarm sounders,
controls and inputs. It is a variant of the BC-420
Controller prepared for rack installations. Together
with the IO modules the unit will have the full
functionality of the BC-420 Controller.
Dimensions:
3Ux12HPx200mm
Power Cabinet STX Range with power supply
The Power Cabinet STX is available in three different
versions, including either a 2A, 5A or 10A power
supply. All versions have space for two 12V/18Ah
batteries (not included).
If larger batteries are required, a battery box can be
ordered separately. The battery box provides space
for two 12V/65Ah batteries (not included).
Power supply failures that may occur must be reported
to the AutroSafe panel. In order to report such failures,
an additional input module is required. Other input
modules can be used for this purpose, for example,
BN-303, BN-304 or BN-305.
Dimensions power cabinet:
HxWxD (mm): 420 x 400 x 80
Dimesions battery box:
HxWxD (mm): 534 x 465 x 268
For further information, see datasheet.
To Next Page
Loading...
Need help?
General
