BS100 DYFI Operators handbook
P-BS100/FE - Rev.F / Doc/ 980114 21 Autronica Fire and Security AS
7.1.1 Disable address
When disabling an address (detector, manual call point or an interface unit),
the address will be isolated and not generate an alarm, prewarning or fault as
long as the disabling lasts.
If “OUT/IN-CONTROL”, “DISABLE” and then “ADDRESS” are selected,
the following text will appear in the display:
DISABLE ADDRESS(ES)
SELECT ADDRESS 0000 RET MM
Select the address no. to be disabled and press ↵
↵↵
↵.
The following text will appear in the display:
1 ADDRESS(ES) ENTERED FOR DISABLEMENT
ADDRESS XXXX TIME RET MM
The selected address is ready to be disabled.
This address is not yet disabled, - only prepared for disablement!
The next address (XXXX) will automatically appear. Select this or another
addres by pressing ↵
↵↵
↵ .
If selected address is not present in the system, the following text will
appear in the display:
THE ADDRESS DOES NOT EXIST IN PANEL
LEGAL ADDRESSES xxxx TO XXXX
xxxx - lowest address in the system.
XXXX - highest address in the system.
When all addresses to be disabled are selected, move the cursor to “TIME”
by means of the arrow key and press
↵
↵↵
↵.
The following text will appear in the display:
DISABLEMENT OF n ADDRESS(ES)
DURATION 02 HOURS RET MM
n = number of addresses ready for disablement.
The time limit is automatically set to 2 hours (default value).
Press ß Ý to select other values and press ↵
↵↵
↵ .
Disable address
To Next Page
Loading...
