Autronica BS-100 DYFI - Restore Controls; Restore BT-Outputs (DHM, AUX)

BS100 DYFI Operators handbook
P-BS100/FE - Rev.F / Doc/ 980114 27 Autronica Fire and Security AS
When correct zone number is selected, move the cursor to “OK” , press ↵
↵↵
↵
and the following text will appear in the display:
ZONE YYY RESTORED
MORE ? YES NO
YYY is selected and restored zone.
If more than one zone is to be restored, select "YES", press ↵
↵↵
↵ and repeat the
restoring procedure.
Select "NO" to end the "RESTORE ZONE"-menu.
7.2.3 Restore controls
By restoring the controls, these will activate at alarm.
If "OUT/IN-CONTROL", "RESTORE" and then "CONTROLS" are
selected, the following text will appear in the display:
RESTORE OUTPUT CONTROLS
BT-OUTPUTS CONTROLS RET MM
7.2.3.1 Restore BT-outputs (DHM, AUX)
By restoring BT-outputs, the outputs DHM (door holder magnets) and AUX
(control-/alarm output) will activate at alarm.
If "OUT/IN-CONTROL", "RESTORE", "CONTROLS" and then "BT-
OUTPUTS" are selected, the following text will appear in the display:
RESTORE OUTPUT CONTROLS
RESTORE COMPLETED
Press ↵
↵↵
↵, and the system will return to the "RESTORE CONTROLS" with
possibility to return to the main menu.
Restore controls