BS100 DYFI Operators handbook
P-BS100/FE - Rev.F / Doc/ 980114 25 Autronica Fire and Security AS
7.1.5 Disable Fire Brigade (BMA, BMFO, BMF)
When disabling the Fire Brigade output (BMA), prewarning (BMFO) and
fault output (BMF) will also be disabled
If “OUT/IN-CONTROL”, “DISABLE” and then “FIRE BRIGADE” are
selected, the following text will appear in the display:
DISABLEMENT OF FIRE BRIGADE OUTPUT
DURATION 02 HOURS RET MM
Select duration time by means of the arrow key and press ↵
↵↵
↵.
The following text will appear in the display:
DISABLEMENT OF FIRE BRIGADE OUTPUT
DISABLEMENT EXECUTED
Press ↵
↵↵
↵, and the system will return to the “DISABLE”-menu with
possibility to return to the main menu.
7.2 Restore
When disable parts of the system (functions) are restored, these will revert
to their normal function.
The “FUNCTION DISABLED” lamp will turn off only when all
disablements have been retsored.
If “OUT/IN-CONTROL” and then “RESTORE” are selected, the following
text will appear in the display:
RESTORE: SELECT WITH ⇐
⇐ ⇐
⇐ Þ
ÞÞ
Þ
PRESS ↵
↵↵
↵
ADDRESS ZONE CONTROLS SOUNDERS ß
ßß
ß
("RESTORE", "FIRE BRIGADE" will appear when ß is pressed.)
7.2.1 Restore address
Before restoring addresses it is always advisable to check the sensitivity to
ensure that an alarm is not present.
By restoring the address(es), the addresses will revert to their normal
function.
Disable
Fire Bri
To Next Page
Loading...
