AUX air conditioner service manual
70
b) When the air-conditioner turns off, the timing close function can be set by pressing the “timing”
button if there is no time setting. It enters the time regulatory setting moment and the primary setting
is six hours. Press the “plus” or “minus” button on the remote controller can set the timing close time
(1~24h), and the minimum setting time is one hour. Repress the “timing” button for confirming the
setting time, and the air-conditioner starts the timing close function. The double “8” on the panel used
for showing the indoor temperature is displaying the indoor temperature and the balanced time of the
setting close time by returns. The interval cycle between the two displays is 5 seconds, and the
minimum time unit for display is 1 hour. When the timing close time is over, the air-conditioner turns
on automatically and the timing close function is cancelled.
c) When setting the timing start function, the working mode, setting fan speed, setting temperature and
air grid functions etc. can also be set. After the timing time expires, the air-conditioner runs according
to the above setting functions.
d)The timing status under display can be cancelled by pressing the “timing” button. Press the on-off
button to run according to the pre-setting conditions.
②“mode” button
Press“mode”button, the operation modes of the Heat pump unit is in cycle according to the sequence
of: cooling→dehumidifying→ventilating→heating. The cooling only unit is in modes cycle according
to the sequence of：cooling→dehumidifying→ventilating.
③“electric heating” button
The electric heating unit can set or cancel the electric heating function by this button only when it’s
under heating mode.
④“sleep” button
The sleeping function can be set or cancelled by this button only under the cooling, dehumidifying and
heating modes.
⑤“strong fan” button
The strong fan function can be set or cancelled by this button only under the cooling, dehumidifying
and heating modes.
⑥“plus”button
The function is in accordance with the one of “plus” button on the display panel.
⑦“minus” button
The function is in accordance with the one of “minus” button on the display panel
⑧“up and down fan” button
Set or cancel the up and down fan grid.
⑨“right and left fan” button
Set or cancel the right and left fan grid.
To Next Page
Loading...
Need help?
General
