Parameter name Default value Description and value range
PUSHCAP 2222 Push capabilities. Valid values are any three or four digit
combination using only the digits 0, 1, or 2.
PUSHPORT 80 TCP listening port number used for the deskphone’s
HTTP server. 2 to 5 ASCII numeric digits, 80 through
65535.
QKLOGINSTAT 1 Quick login permission flag. Valid values are:
1= Quick login permitted; user must press the pound (#)
key to see the previous Extension and Password.
0= Quick login not permitted; the user must explicitly
enter the extension and password.
QLEVEL_MIN 4 Valid values are 1 to 6
Specifies the minimum quality level in which a low local
network quality indication will not be displayed.
QTESTRESPONDER “ ” (Null) Specifies the IP address to which Qtest messages should
be sent. The device at this address must support the
echo service on UDP port 7, as specified in IETF RFC
862. Format is dotted decimal, colon-hex, or DNS format,
separated by commas, with no spaces. Zero to 255 ASCII
characters, including commas.
RECORDINGTONE 0 Recording tone permission flag. (0=Recording tone is
disabled, 1= Recording tone is enabled).
When recording tone is enabled, when the agent is on an
active call or conference call, the deskphone inserts a
tone into the audio stream every 15 seconds, so that both
the user and the far end hears it. The recording tone has
a frequency of 1400 Hz and a duration of 0.2 seconds.
RECORDINGTONE_INTER
VAL
15 Recording tone interval. The number of seconds between
recording tones, with a range from 1 to 60.
RECORDINGTONE_VOLU
ME
0 Volume of Recording tone played. (1 or 2 ASCII digits
from ‘0’ to ‘10’). The default plays the Recording tone at
the same volume as the rest of the audio path; each
higher number reduces the volume by 5 db.
REREGISTER 20 Registration timer in minutes. Controls an H.323 protocol
timer that should only be changed under very special
circumstances by someone who fully understands the
system operation impact. Value is 1-120.
REUSETIME 60 The number of seconds to wait for successful completion
of DHCP before reusing previous parameters on the
default (port) VLAN. Valid values are 1 to 3 ASCII
numeric digits, 0 and 20 through 999.
RFSNAME “ ” (Null) Applies only to deskphones running software Release 6.0
and later. The file name of the Signed Kernel/Root
Table continues…
Administering Deskphone Options
March 2018 Administering Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP Deskphones H.
323 95
Comments on this document? infodev@avaya.com
To Next Page
Loading...
