Note:
Use the Right navigation arrow to scroll through the viewable information where
indicated in Table 2: Parameter Values on page 67.
Table 2: Parameter Values
Name System Value Format
Phone (IPv4) nnn.nnn.nnn.nnn Deskphone IP Address;
IPADD value.
Phone (IPv6) hhhh:hhhh::hhhh:hhhh:hhhh Deskphone IP Address;
NVIPADDV6 value.
Phone (IPv6LL) hhhh:hhhh::hhhh:hhhh:hhhh Deskphone IP Address;
IPADDV6LL value.
Call Server nnn.nnn.nnn.nnn IP Address of the call server
currently in use, otherwise
“0.0.0.0.”
Supplicant ccccccccccccccccc Text equivalent of
DOT1XSTAT: if 0, Disabled; if
1, Unicast-only; if 2, Unicast/
multicast.
Pass-thru ccccccccccccccccc Text equivalent of DOT1X; if
0, Enabled; if 1, Enabled w/
Logoff; if 2, Disabled.
Router (IPv4) nnn.nnn.nnn.nnn Up to 15 ASCII characters:
the IP Address of the router
in use.
Mask (IPv4) nnn.nnn.nnn.nnn Up to 15 ASCII characters:
NETMASK value.
HTTP server nnn.nnn.nnn.nnn IP Address of last HTTP
server used successfully
during initialization or
“0.0.0.0” if no file server was
used successfully.
HTTPS server nnn.nnn.nnn.nnn IP Address of last HTTPS
server used successfully
during initialization or
“0.0.0.0” if no file server was
used successfully.
802.1Q cccc Text string corresponding to
the L2Q value.
VLAN ID cccc Up to 4 ASCII characters.
Value is L2QVLAN text
“Auto” if 802.1Q tagging is 0
Using the VIEW craft procedure for troubleshooting
H.323 Installation & Maintenance Guide R6.1 May 2011 67
To Next Page
Loading...
