Avaya IX Collaboration Unit CU360 - Connecting Avaya IX CU360; Switching Avaya IX CU360 On or Off

• HDMI cable
• Power adapter
• Rubber cap for camera
Procedure
1. Secure the Avaya IX
™
CU360 endpoint on an external monitor using the hinge at the
bottom of the endpoint.
2. Connect the HDMI cable in the HDMI ports of Avaya IX
™
CU360 and the external monitor.
3. Connect the power adapter.
Switching Avaya IX
™
CU360 on or off
About this task
The power button of Avaya IX
™
CU360 on the rear of the device. You can use the power button to:
• Switch Avaya IX
™
CU360 on or off.
• Change the Avaya IX
™
CU360 mode to standby or wake up the device from the standby
mode.
Procedure
Do one of the following:
• To switch Avaya IX
™
CU360 on or off, press and hold the power button.
• To change the mode of Avaya IX
™
CU360 to standby or wake up the device from the standby
mode, press the power button.
Initial setup and connectivity
April 2020 Installing and Administering Avaya IX Collaboration Unit CU360 26
Comments on this document? infodev@avaya.com