Avaya IX Collaboration Unit CU360 - Testing Network Connections; Verifying Acoustic Pairing

Testing the Avaya IX
™
CU360 network connections
Procedure
1. Do one of the following:
• On the endpoint main menu, click Configure > System Status > Diagnostics >
Network > Tests.
• On the web interface, click Diagnostics > Network.
2. Do one of the following:
• On the endpoint, enter an IP address, and click Ping.
• On the web interface, click Ping.
3. On the web interface, enter the IP address, and click Ping.
Verifying acoustic pairing in Avaya IX
™
CU360
Procedure
1. Do one of the following:
• On the endpoint main menu, click Configure > System Status > Diagnostics > I/O
Connections > Audio > Streams.
• On the web interface, click Diagnostics > I/O Connections > Audio > Streams.
2. Select one of the following streams to view the status:
• Tx: Transmitting audio stream
• Rx: Receiving audio stream
Testing acoustic pairing in Avaya IX
™
CU360
About this task
Test acoustic pairing between Avaya IX
™
CU360 and other devices to check for interference from
ambient noises.
Procedure
1. Do one of the following:
• On the endpoint main menu, click Configure > System Status > Diagnostics > I/O
Connections > Audio > Tests.
• On the web interface, click Diagnostics > I/O Connections > Audio > Tests.
Troubleshooting
April 2020 Installing and Administering Avaya IX Collaboration Unit CU360 122
Comments on this document? infodev@avaya.com