Avaya IX Collaboration Unit CU360 - Configuring LAN for Advanced IP Address Settings

Configuring LAN for advanced IP address settings in
Avaya IX
™
CU360
About this task
After you save the settings on Avaya IX
™
CU360 web interface, you must log in to Avaya IX
™
CU360 web interface again.
This configuration is available only if your administrator enables the advanced settings for users.
Procedure
1. Do one of the following:
• On the endpoint main menu, click Configure.
• On the web interface, click Administrator Settings.
2. On the endpoint, click Advanced.
The default PIN for Advanced settings on the endpoint is 1234.
If your administrator configured a PIN to gain access to the advanced settings on the
endpoint, Avaya IX
™
CU360 prompts you to enter the PIN. After you enter the PIN, Avaya
IX
™
CU360 displays the Advanced window.
3. Click Networks > GLAN > Addresses.
4. Configure the following fields:
Endpoint menu Web interface
IP Address Mode Automatic IP Address
IP Address IP Address
Subnet Mask Subnet Mask
Gateway Gateway IP Address
DNS DNS Server IP Address
5. On the web interface, click Save.
Related links
Enabling the Avaya IX CU360 advanced settings on page 37
Configuring network priority settings in Avaya IX
™
CU360
About this task
Configure Avaya IX
™
CU360 to prioritize a specific network connection when Avaya IX
™
CU360
cannot determine the network port from the destination address in the call signal.
When Avaya IX
™
CU360 cannot determine the route of a call by matching the destination address,
Avaya IX
™
CU360 uses the preferred network port.
Advance administration
April 2020 Installing and Administering Avaya IX Collaboration Unit CU360 86
Comments on this document? infodev@avaya.com