5. To pair a device, scroll to the headset, and press Pair.
6. To disconnect a paired headset, under Paired devices, press Disconct.
7. To unpair a paired headset, under Paired devices, press Forget.
Turning button clicks on and off
Procedure
1. Press Main Menu.
2. Scroll to Settings and press Select.
3. Scroll to Audio settings and press Select.
4. Use the Down Arrow key to go to the Button clicks screen.
5. Press Toggle to turn the audio on or off.
6. Press Save.
Turning error tones on and off
About this task
Use this procedure to activate the error tone alarm when you perform an incorrect action while
using the phone.
Procedure
1. Press Main Menu.
2. Scroll to Settings and press Select.
3. Scroll to Audio settings and press Select.
4. Use the Down Arrow key to go to the Error tones screen.
5. Press Toggle to turn error tones on or off.
6. Press Save.
Enabling wireless headset bidirectional signaling
Before you begin
Check if the headset supports electronic hook switch (EHS) signaling.
Note:
Headset Signaling setting is used to configure only DECT headsets and cannot be applied to
Bluetooth headsets.
Audio
February 2022 Using Avaya J159 SIP IP Phone in Open SIP 145
Comments on this document? infodev@avaya.com
To Next Page
Loading...
