Avaya RADVISION Scopia XT5000 - Page 36

If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Server Locally from the Endpoint on page 45.
To modify the PIN, you must be connected via HTTPS (see below).
Procedure
1. Access the remote management settings, as follows:
•
From the XT Server web interface, select Administrator Settings > Utilities >
Remote Access > Web.
•
From the endpoint's main menu, select Configure > Advanced > Utilities > Remote
Access > Web from the Main menu.
Figure 17: Configuring remote management on XT Server
2. Set the fields as described in Table 9: Configuring remote management on XT Server on
page 36.
Table 9: Configuring remote management on XT Server
Field Name Description
Web Management Configure whether to allow remote management via the web
interface, as follows:
•
Select Yes to enable remote management of the XT Server
from its web interface.
•
Select No to disable remote management of the XT Server from
its web interface.
HTTPS Configure your web security settings, as follows:
•
Select Yes to enable secure HTTPS connection to the web
when remotely managing the XT Server from its web interface.
•
Select No to disable secure HTTPS connection to the web. For
example, if you remotely configure your endpoint only from
within your network, it may not be necessary to use HTTPS.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2 Initial Configuration | 36