62 Model E1070 Indicator User Instructions
Indicator Operations
5.9 Counting
Press the MODE key to scroll
through the activated applications.
The name of the active application
will be briefly displayed or, press
and hold the MODE key for 3-5
seconds to see the name of the
currently active application.
This indicator has an 11 channel
PLU (Product Look Up) memory.
To access a memory channel, key
in a number from 0 to 10, then
press the ENTER key.
This section applies if your indicator has the counting application active.
Applications are activated through a password protected menu. Contact
your local Avery Weigh-Tronix supplier or distributor for assistance.
There are two types of sampling; bulk and dribble. See the Supervisor Menu
on page 31 and COUNT Application on page 40
Bulk sampling In this sampling method you place the specified number
of items on the scale all at once (in bulk) and the scale
automatically starts to calculate piece weight and then
shows the count.
Dribble sampling In this sampling method you can count out the specified
number of items onto the scale and when you are ready,
press the F1 key and the scale starts to calculate piece
weight and then shows the count.
Each method is described below.
Bulk Sampling 1. In gross weight mode, press the F1 key…
A numeric value is displayed. This is the current sample size.
2a). Accept the current sample size by pressing ENTER
OR
2b). Enter a new sample size and press ENTER…
Zeroin is briefly displayed. This shows the indicator is zeroing
itself. Add is then displayed.
3. Place the correct sample size on the scale all at the same time.
Busy is briefly displayed, followed by one of two possible
outcomes:
The display is showing counts
when the green annunciator on the
right of the display is lit.
a. If the sample met the minimum sample requirements and the
weight is stable, the display will show the correct number of
parts on the scale and the green annunciator is lit.
b. If the sample size was not large enough or if the weight was
unstable, Abort is displayed and the display returns to gross
weight mode. Repeat steps 1-3 using a larger sample size.
4. Place the parts on the scale to be counted.
5. You can accumulate the counts and track the number of transactions
by pressing the PRINT key while in count mode. See Displaying
Count Information on page 63 about displaying this information.
To Next Page
Loading...
Need help?
General
