Model E1070 Indicator User Instructions 63
5.9 Counting
Dribble Sampling 1. In gross weight mode, press the F1 key…
A numeric value is displayed. This is the current sample size.
2a). Accept the current sample size by pressing ENTER
OR
2b).Enter a new sample size and press ENTER…
Zeroin is briefly displayed. This shows the indicator is zeroing
itself. Add is then displayed.
3. Place the correct sample size on the scale and press the F1 key…
Busy is briefly displayed, followed by one of two possible
outcomes:
a. If the sample met the minimum sample requirements and the
weight is stable, the display will show the correct number of parts
on the scale and the Count annunciator is lit.
b. If the sample size was not large enough or if the weight was
unstable, Abort is displayed and the display returns to gross
weight mode. Repeat steps 1-3 using a larger sample size.
4. Place the parts on the scale to be counted.
5. You can accumulate the counts and track the number of transactions
by pressing the PRINT key while in count mode. See Displaying
Count Information below about displaying this information.
If the piece weight of the item being counted is known, you can manually
enter the piece weight by keying in the weight with the keypad and pressing
and holding the SELECT key.
Displaying Count
Information
You can scroll through the following information by using the SELECT key:
From count display-
press SELECT - The display toggles between PIECE and the piece
weight.
press SELECT - The display toggles between CNT TOT and the count
total.
press SELECT - The display toggles between TOTAL and the number of
accumulations done.
press SELECT - The Gross annunciator lights and gross weight is
displayed.
press SELECT - The Net annunciator lights and net weight is displayed.
press SELECT - The Tare annunciator lights and tare weight is displayed.
press SELECT - The count display returns.
To Next Page
Loading...
Need help?
General
