Avidsen V250 - Advanced Settings; Copy Programming; Deleting All Remote Controls; Menu

EN 24
D - BEGINNING OPERATION
2.2.1. PROGRAMMING WITH THE CARD
Programming a button for the COMPLETE
OPENING command:
• Press on PROG 2 or 3 times and the green LED
should be switched on (only the green LED)
• Press “–” for 3 seconds and L1 will switch on.
• Press OK and L1 and L4 will turn on alternately.
•While the indicators are ashing, press the
remote control button to be memorised.
• The red LEDs will all switch on for 1 second
(memorisation is successful).
IftheredLEDsswitchoffwithouthavingashed,
this means that the system has exceeded the 10
second wait without anything being conrmed.
Restart programming.
Programming a button for the PARTIAL
OPENING command:
• Press 2 or 3 times on PROG and the green LED
should be switched on (only the green LED)
• Press “–” for 3 seconds and L1 will switch on.
• Press “+” and L1 will switch off and L2 will switch
on.
• Press OK and L1 and L4 will turn on alternately.
•While the indicators are ashing, press the
remote control button to be memorised.
• The red LEDs will all switch on for 1 second
(memorisation is successful).
IftheredLEDsswitchoffwithouthavingashed,
this means that the system has exceeded the 10
second wait without anything being conrmed.
Restart programming.
2.2.2. COPY PROGRAMMING
From a remote control that has already been
memorised, you can memorise other remote
controls (“copy” function).
For each new remote control to be memorised,
follow the procedure below
• Stand near the motor.
• Press simultaneously on both buttons at the
bottom of the remote control already in the
memory until the ashing light switches on
(around 6 seconds).
• Press the button of the new remote control to be
memorised,theashinglightwillash3timesto
conrmthenewremotecontrol.
The new remote control is now memorised (the
buttons will have the same function as the original
remote control).
2.3. DELETING ALL REMOTE CONTROLS
To unprogramme all the remote control buttons
learnt, follow the procedure below
• Press on PROG 2 or 3 times and the green LED
should be switched on (only the green LED)
• Press “–” for 3 seconds and L1 will switch on.
• Press “+” twice and L1 will turn off and L3 will
turn on.
• Press OK. The 4 red LEDs will turn on.
• Press OK for 3 seconds. All the LEDs will turn off
andturnontoconrmtheoperation.
All the remote controls will be deleted from the
memory.
3. ADVANCED SETTINGS
In this part we are going to see how to perform
the remote settings. Below is the list of possible
settings:
• MENU 1
- Operating mode (automatic closing or semi-
automatic closing)
- Time delay (for automatic mode)
- Motor force
- Motor speed
• MENU 2
- Acceleration/deceleration at end of travel
- Photocell mode
- Type of gate
- Stop tolerance
• MENU 3
- Closing time interval
-Flashinglightpre-ashingtime