IFD500 Series Pilot Guide
Aux Subsystem 5-19
Editing a Checklist
To edit an existing checklist, touch or use the bottom right knob to
select the “Edit” button, then touch again or push the knob putting
the system in edit mode. This automatically creates a new step at
the end of the checklist – if that’s what you want, then just start
typing on the keyboard. If instead, an existing step is to be edited,
then select the checklist step to be edited by touching it or using
the inner knob. Touch the step a second time or push the knob to
generate a keyboard, press the CLR button (keyboard or bezel)
as required to clear characters and then re-type as required. To
insert a missing/extra step, type the step as desired as the last
step of an existing checklist and then turn the outer knob to insert
the step in the desired location. When done with editing the
existing checklist, touch/select the “Edit” button again to exit edit
mode.
Press the “CLR” button on the bezel to return to the checklist
directory.
Selecting a Checklist
From the checklist directory, highlight the desired checklist by
either touching it or using the bottom right knob and then either
touch the checklist title a second time or push the knob to select
it.
The selected checklist will then be displayed with the checklist
title along the top strip.
Using a Checklist
When a checklist is selected for use, the first step will be
highlighted by a bright blue wrap-around highlight. Either
touching a highlighted step or pushing the knob will toggle that
step to bright green. A green checkmark will appear along the
right edge, indicating that checklist step has been accomplished.
To Next Page
Loading...
